PGM Stroboscope Module

The PGM Stroboscope Module is a free running pulse generator that causes any attached light to strobe at the set pulse rate. This independent unit provides a strobe signal allowing any Smart Vision Lights product to strobe at a set frequency without the presence of an NPN or PNP trigger. This unit easily integrates between your power source and the LED array using a male to female M12 connection. It operates at a 10% duty cycle, meaning that the light will be active for 10% of the period and inactive for 90%. of the period. The pulse rate can be set to any frequency from 12 to 3200 Hz with 2 rotary dials. The first dial has 8 positions consisting of 12, 25, 50, 100, 200, 400, 800, and 1600 Hz. The second dial allows the user to finely adjust the frequency set by the first dial. This dial can be set up to 2 times the frequency of the first dial. The Stroboscope Module can be used on standard or OverDrive LED lights.

PTM Module

Smart Vision Lights products are pulse following and will track the camera’s lighting strobe signal. Some cameras are pulse initiated and are not pulse following. High speed cameras operate by initiating with a strobe pulse but then expect the light to hold output for a set time or duration. The Pulse Initiated Timing Module accepts a pulse of 5µs or longer and holds the pulse for the selected duration. The PTM allows the user to select a pulse length from 8 preset durations of 20, 50, 100, 250, 500, 750, or 1000 microseconds. The Module has a male M12 connector input which will connect to the camera and a female M12 output which will connect to Smart Vision Lights.